Attribute Name |
Description |
Implementation Details |
---|---|---|
IJUAhsBasePlate1:: BasePlate1Part |
Specifies the part number or part class of the first base plate. To select the part using BasePlate1Rule, do not type any value for this property. |
|
IJUAhsBasePlate1Rl:: BasePlate1Rule |
Defines an HgrSupportRule that returns a part number or part class to use for the base plate. To select the part directly using BasePlate1Part, do not type any value for this property. |
|
IJUAhsBasePlate1Ang:: BasePlate1Angle |
Specifies the angle that BasePlate1 should be rotated about the Z-axis of the port to which the plate is attached. |
|
IJUAhsBasePlate1Off:: BasePlate1Offset |
Specifies the distance by which the base plate should be offset from leg1. BasePlate1Offset is applicable only when StructureConnection is set to either Lapped or Lapped-Opposite. |
|
IJUAhsBolt1::Bolt1Part |
Specifies the part number or the part class of the bolts connected to BasePlate1. To select the part using Bolt1Rule, do not type any value for this property. |
|
IJUAhsBolt1Rl::Bolt1Rule |
Defines an HgrSupportRule that returns a part number or the part class to use for the Bolts. To specify the part directly using Bolt1Part, do not type any value for this property. |
|
IJUAhsBolt1Qty::Bolt1Quantity |
Specifies the quantity of bolts to include on BasePlate1. Usually, 2 or 4. The following properties are applicable for all frame types: |
|
IJUAhsBolt1Offset1:: Bolt1Offset1 |
Specifies the offset value for Bolt1Part from the edge of the plate to the center of the bolt along the x-axis of the pipe. |
|
IJUAhsBolt1Offset2:: Bolt1Offset2 |
Specifies the offset value for Bolt1Part from the edge of the plate to the center of the bolt along the y-axis of the pipe. |