The following attributes are only used if a repad part has been specified. If the repad is shown as part of the Dummy Leg SmartPart these attributes will be ignored.
Name |
User Name |
Category |
On Property Page |
Read Only |
---|---|---|---|---|
RepadThickness |
Repad Thickness |
Dimensions |
Yes |
No |
RepadThicknessSelection |
Repad Thickness Selection |
Dimensions |
No |
Yes |
RepadThicknessRule |
Repad Thickness Rule |
Dimensions |
No |
Yes |
RepadThicknessDefinition |
Repad Thickness Definition |
Dimensions |
No |
Yes |
Attributes |
Description |
Implementation Details |
---|---|---|
IJUAhs_RepadTh:: |
Total thickness of the Repad. |
Default units are specified on the CustomInterfaces sheet. Specify the units otherwise. IE: |
IJUAhs_RepadThRl:: |
An HgrSupportRule that returns a numerical value for RepadThickness. The Hanger Rule should be present in the catalog; it can be a rule Name or ProgID. If you intend to use RepadThickness to directly specify the length, then this attribute should be left blank. |
IE: Rule ProgID: |
IJUAhs_RepadThSel:: |
Determine which attribute is used to set RepadThickness. If no value is given, the RepadThickness attribute will be used by default. Note: If the Dummy is being used as a sub assembly, check to see if the RepadThicknessOverride attribute has been set by the parent assembly |
hsSelection 1 = By Rule 2 = By Input |
IJUAhs_RepadThDef:: |
The definition of the RepadThickness value. This attributes specifies how the attachment should be measured. If a value is set for RepadThickness but no definition is given, an error will occur. |
Supported Values 1 = Repad Thickness (direct) |