The following dimensions are used by the Limit Stop sub-assembly:
Name |
User Name |
Category |
On Property Page |
Read Only |
---|---|---|---|---|
ShoeHeight |
Shoe Height |
Dimensions |
Yes |
No |
Angle1 |
Angle 1 |
Dimensions |
Yes |
No |
Angle2 |
Angle 2 |
Dimensions |
Yes |
No |
Angle3 |
Angle 3 |
Dimensions |
Yes |
No |
ConnectTo |
Connect To |
Dimensions |
Yes |
No |
SpanOver |
Span Over |
Dimensions |
Yes |
No |
StructureConnection |
Structure Connection |
Dimensions |
Yes |
No |
StopClearance |
Stop Clearance |
Dimensions |
Yes |
No |
Attribute Name |
Description |
Implementation Details |
---|---|---|
IJUAhsShoeHeight:: |
Specifies the shoe height of the limit stop. |
|
IJUAhsAngle1::Angle1 |
Specifies the ShoeAngle1 of the limit stop support. |
|
IJUAhsAngle2::Angle2 |
Specifies the ShoeAngle2 of the limit stop support. |
|
IJUAhsAngle3::Angle3 |
Specifies the ShoeAngle3 of the limit stop support. |
|
IJUAhsConnectTo:: |
Specifies the codelist value that determines whether the limit stop connects to a pipe or a supporting steel. |
|
IJUAhsSpanOver:: |
Specifies the span measurement. This attribute is valid only when the structure connection is set to 1. |
|
IJUAhsStructure |
Specifies the location of the limit stop and the position from where the limit stop clearance is measured. |
|
IJUAhsStopClearance:: |
Specifies the space between the limit stop and the edge of the supporting steel. |
For more details on these attributes, refer Limit Stop.