Set Piping and Equipment Ranges - Intergraph Smart P&ID - Help - Intergraph

Select an insulation specification in the Tree view.

Select Edit > Properties Command to display the Insulation Specification Dialog.

Select Range Setup to open the Piping Range Setup Dialog. You can select Range Setup on the Piping Tab or Equipment Tab to display the corresponding range setup dialog.

Select nominal diameters, and inspect the results in Resulting ranges. Diameter ranges are required only for piping.

• You can delete diameter values after selecting them.

• Values in the Nominal diameter list are specified in select lists in Data Dictionary Manager.

On the Piping Range Setup Dialog or the Equipment Range Setup Dialog, type in temperature values in the Temperature area, and inspect the results in Resulting ranges.

• If necessary, you can select a temperature value from the list and delete it.

• The temperature range refers to the operating range for the insulation specification only. It is not constrained to match any defined temperature for the item you want to insulate in the design software.