Calibration analysis - HxGN EAM - Help - Hexagon

Report EAM

Language
English
Product
HxGN EAM
Search by Category
Help
HxGN EAM Version
11.7.1

Description

Displays a list of completed calibration work orders by department that have resulted in the specified minimum number of consecutive or non-consecutive calibration statuses of pass or fail.

The report allows you to identify patterns in the results of calibration work orders to determine whether the frequency of calibration PMs should be adjusted, whether the equipment should be replaced, etc.

Using Min. # of Calibrations, the system determines the actual number of completed calibration work orders to retrieve for the report. If the actual number of completed calibration work orders is less than the value specified for Min. # of Calibrations, the system does not display any results. However, if the number of completed work orders is greater than or equal to the value of Min. # of Calibrations, the system displays all of the work orders.

Calibration work orders are considered consecutive if there are no other work orders for the equipment containing test points that were completed between the work orders in question.

Menu Path

Work > Reports > Calibrations > Calibration Analysis

Parameters

Specify the Organization, Department, System, Equipment, Class, Category, and Equipment Criticality.

Min. # of Calibrations - Specify the minimum number of work orders to retrieve for each piece of equipment based on the selection criteria. Min. # of Calibrations is a required field. Select one or more of the following options:

  • Non-Consecutive - Select to print a list of all calibration work orders. If Non-Consecutive is unselected, the system only prints a list of consecutive work orders meeting the specified criteria.

  • Include Pass With Fail - Select to include all work orders with a calibration status of Pass, fail exists (PF).

  • Include Pass With Recal - Select to include all work orders with a calibration status of Pass, recal exists (PR).

  • Include Incomplete - Select to include all work orders with a calibration status of Incomplete.

  • Print Test Point Comments - Select to print comments entered for test points in the report output.

Calibration Status - Select one of the following options:

  • Pass - Select to include only work orders with a status of Pass (P).

  • Fail - Select to include only work orders with a status of Fail (F).

Start Date and End Date - Specify the starting and ending date for which to retrieve data. End Date is a required field.

Report Type

Consumer