Local Sketches
Stores the properties for local detail sketches and information notes.
Open the grid, and then define the attributes listed below as needed.
-
Identifier specifies the detail sketch or Information note string identifier. The following are examples:
-
Detail Sketch - SK1.dxf
-
Information Note - note_N.dxf or note_S.dxf
-
-
For AutoCAD and SmartSketch, the file format extension must be shown in the ID, such as SK1.dxf or SK1.igr.
-
For MicroStation, specify just the name of the sketch as found in the graphic cell library, as in SK1.
-
Inclusion of _N - as in GenNote_N.dxf or GenNote_N - as part of the information note name signifies a general note, which is output on every sheet.
-
Inclusion of _S - as in SpecNote_S.dxf or SpecNote_S - signifies a specific note, which is only output on the sheet on which the component having this particular note attached is output.
-
Height specifies a single value for the height of the detail sketch or information note in millimeters.
-
Width defines the width of the detail sketch/information note. Type a single value in millimeters.
-
Label X specifies the horizontal cross-reference position measured from the bottom left corner of the detail sketch in millimeters.
-
Label Y specifies the vertical cross-reference position measured from the bottom left corner of the detail sketch in millimeters.
-
Text Height sets the text height to be used. Type a value in millimeters or inches, depending on the setting of the drawing units.
The value that displays on the Local Sketches icon is a count of how many attributes have been defined for output in the user-defined cut list. The example below indicates that three attributes are currently defined.