-
List controls the form of list to be output. Specify CONTINUOUS-DOWN or CONTINUOUS UP. This is a mandatory setting.
-
Start Position identifies the start position for the output of the bolting Information, where X pos and Y pos are input in millimeters, either real (one decimal place) or integer, such as 225, or 225.0, or 225.5). This is a mandatory setting.
START-POSITION X pos Y pos
-
Vertical Spacing specifies the vertical spacing required between each horizontal line of text on the bolting information list, where the value is input in millimeters, either real (one decimal place) or integer, such as 6, 6.0, or 6.2). This is a mandatory setting.
VERTICAL-SPACING value
-
Max Number of Lines specifies the maximum number of output lines that can fit on the backing sheet, where the value is an integer number. This is a mandatory setting
MAXIMUM-ENTRIES value
-
Text Height specifies the height of the characters in the text to be output on the bolting information list, where value is real (one decimal place) or integer, such as 2, 2.0, or 2.3). This is a mandatory setting.
TEXT-HEIGHT value (in mm)
-
Drawing Layer identifies the drawing layer for outputting the text on to (where value is an integer number that is valid for the graphics system being used). This is an optional setting.
DRAWING-LAYER value
-
Text Thickness (Weight) identifies the text thickness (weight) for all output text to the bolting information list, where the value is an integer number that is valid for the graphics system being used. This is an optional setting.
TEXT-THICKNESS value
An example of the BOLTING-INFO-CONTROL section is shown below:
BOLTING-INFO-OUTPUT - - - - - - - Section Header
BOLTING-INFO-CONTROL
CONTINUOUS-DOWN
START-POSITION 450.0 106.0
VERTICAL-SPACING 4.0
TEXT-HEIGHT 2.5
MAXIMUM-ENTRIES 12
DRAWING-LAYER 16
TEXT-THICKNESS 2