Set Center Point - Intergraph Smart Review - Help

Intergraph Smart Review Help

Language
English
Product
Intergraph Smart Review
Search by Category
Help
SmartPlant Foundation / SDx Version
7.1 (2018 R1)
Smart Review Version
13.x(2018)
  1. Click View > Settings > View.

    You also can click the Center View command on the Common toolbar.

  2. Click the View Cone tab.

  3. Verify the North center point setting.

  4. Verify the East center point setting.

  5. Verify the Elevation center point setting.

  • Place the center point by clicking View > Place > Center Point Only, which allows you to place the center point by locating a 3D point using one or more of the graphic views. For more information, see Placing 3D Points.

  • Place the center point by clicking View > Place > View by Center Point, which repositions the model in a view and is useful for seeing different portions of the model.

  • Set the center point interactively by using the mouse to drag the center point of the view cone in the Plan or Elevation views. You must hold the left mouse button down for at least one second or drag it at least 8 pixels before the eye point adjustment mode allows the center point to change. See the README file for information about changing these defaults. You can right-click or press ESC to cancel the center point adjustment without saving the changes. Any changes to the center point made in this manner can be reversed using the Edit > Undo command.

  • If the eye and center points get too close together, some viewing operations cease to function properly. To correct this problem, place a new center point, enter new values for the eye and/or center points and viewing angles on the View > Settings > View > View Cone tab, or use the Position Control toolbar to adjust the eye point, center point, and viewing angles.

See Also

Using the View Cone
Set Eye Point
Set Clipping Planes
Set View Cone Display
Position Control Toolbar