Parts overlapping methods - Intergraph Smart Production - Help - Hexagon PPM

Intergraph Smart Production Profile

Language
English (United States)
Product
Intergraph Smart Production
Search by Category
Help
Smart Production Version
20

This table describes the methods available for slanting ends. You select the method using the Parts overlapping property on the Cut Method Settings Properties tab.

Method 0

No overlapping; leave one width of the tool (t) between the two parts.

method0

Method 1

No overlapping; leave one width of the tool (t) between the two parts. Kerf breadth (tβ) is compensated when necessary.

Method 2

No overlapping; there is a straight angle between parts. Angled edges are cut separately. Length of cut tolerance (c) is added between the parts.

Method 3

Overlap identical edges; otherwise, straight cut is required between the parts.

Method 4

Overlap identical angles; otherwise, length of cut tolerance (c) is added between the parts

Method 5

Overlap; cut tolerance is not used.

Method 6

Overlap; cut tolerance (c) is added between the parts except for identical angles.

Method 7

Overlap; cut tolerance (c) is added between the parts.

Method 8

Overlap identical angles; otherwise, cut tolerance (c) is added between the parts.