Draw a Fillet - Intergraph Smart P&ID - 10 - Help - Intergraph

Intergraph Smart P&ID Help

Language
English
Product
Intergraph Smart P&ID
Search by Category
Help
Smart P&ID Version
10
Smart Engineering Manager Version
11
SmartSketch Version
10.0(2018)
  1. On the Draw toolbar, select Fillet Fillet.

  2. On the ribbon, type a radius in the Radius box.

  3. Select one of the elements that you want to draw the fillet between. You can draw a fillet between arcs, lines, circles, ellipses, and curves.

  4. Select the other element.

  5. Select to draw the fillet.

Fillet

  • You can draw a fillet without typing a radius. Select the two elements you want to use. Then move the pointer to a position that defines the radius, and select.

  • When the elements you want to use cross each other, you can draw a fillet at any of the quadrants. The software trims the remaining elements at the end points of the fillet.

  • You can draw a fillet at a corner with one select. On the ribbon, type a value in the Radius box. Position the pointer over a corner, then select.

  • The value in the Radius box is active until you change it, so you can select one corner after another to draw fillets with the same radius.

  • You can draw a fillet by dragging the pointer over the two elements that you want to draw the fillet between. When you use this method, the Radius box on the ribbon is not active.

See Also

Extending or Trimming Elements
Fillet Command
Fillet Ribbon