Draw an Arc by Defining Three Points - Intergraph Smart P&ID - 10 - Help - Intergraph

Intergraph Smart P&ID Help

Language
English
Product
Intergraph Smart P&ID
Search by Category
Help
Smart P&ID Version
10
Smart Engineering Manager Version
11
SmartSketch Version
10.0(2018)
  1. On the Draw toolbar, select the Arc by 3 Points Command Arc by 3 Points to open the Arc Ribbon.

  2. Select the location to begin the sweep of the arc.

  3. Select the location that you want as midpoint of the arc, and then select the location that you want to end the sweep of the arc, or vice versa.

    Arc by 3 pints

    SHARED Tip Use the intent zones at the first and second points to specify if the third point is between the first two or beyond one of the first two.

Instead of selecting to define the sweep and the midpoint, you can type values on the ribbon. You can also use a combination of graphic and ribbon input.