Tablesuffix - Intergraph Smart Materials - Version 10.1 - Administration & Configuration - Hexagon

Intergraph Smart Materials Integration (10.1)

Language
English
Product
Intergraph Smart Materials
Subproduct
Classic
Search by Category
Administration & Configuration
Smart Construction Version
8
Smart Materials/Smart Reference Data Version
10.1

The following methods for finding tablesuffix data are available.

  • Geom ID

    Selecting the Geom ID method means that the internal Smart Materials ID of the geometry (see S.50.06 GEOM) that is used on S.50.06 in the Geom 1 and 2 fields serves as the tablesuffix for the commodity code. The Geom ID is a number value, which can reach values > 9999.

    With this, Geom1 is considered as the tablesuffix green and Geom2 as the tablesuffix red.

  • Geom S.40.I.01

    The values of Geom1 or Geom2, respectively, on S.50.06 are the basis for the tablesuffix. A translation from S.40.I.01 is taken here instead of the internal Smart Materials ID. In this case, the initial value on PDS 10.01 will be neglected. If a component has only one geometry in its specification but needs two tablesuffixes like for a pre-welding flange, you can assign two tablesuffixes to one geometry as the green and red connect points. Enter the second tablesuffix into the File Name field.

  • S.20.08

    For this method, the mapping name for the Smart Materials table on A.50.I.01 must be TS.

    For the method via S.20.08, it must be indicated in the Source field from which variable attribute the tablesuffix will be read in the mapped table.

    The following possibilities exist:

    • Table Detail - value in TD Code is taken

    • S.20.I.01 - translated value from S.20.I.01 is taken

    • ATTR_CHAR1 - value of ATTR_CHAR1 is taken

    • ATTR_CHAR2 - value of ATTR_CHAR2 is taken

    • ATTR_CHAR3 - value of ATTR_CHAR3 is taken

    • ATTR_NUM1 - value of ATTR_NUM1 is taken

    • ATTR_NUM2 - value of ATTR_NUM2 is taken

    • ATTR_NUM3 - value of ATTR_NUM3 is taken

  • CCG Relation

    The tablesuffix can be found in geometrics that are assigned to the commodity code in M_COMMODITY_GEOMETRIC_RELATION. If more than one geometric is assigned to the commodity code, the first one will be taken, because we assume that if more than one geometric is assigned, either the tablesuffix is the same or only one will have a tablesuffix.

    Because this screen can also be used for other interfaces, the column headers do not fit directly with the PDS interface. The Geometric field will contain the tablesuffix green, and the File Name field will contain the tablesuffix red. This translation must be done for each geometric with a geometric relation to a commodity code used in a PDS pipe spec.