For example, if you want to replace the ‘IN-12’ insulation type with a new insulation type ‘PP-10’ for pipe, create a Search job as described in this chapter.
The picture below shows a BOM position with the INSUL_TYPE attribute.
-
Open B.20.01 Edit BOM.
-
Select the start node.
-
Click Search/Replace .
-
Create a master job.
-
Double-click in the Where Condition field to open A.60.06, and create a Where condition as shown below.
-
Save the Where condition and close A.60.06.
-
Copy the master job, rename the new job, and fill out the List Search and Replace Attrs block as shown below. Use the LOV to select the attribute.
-
Select the INSUL_TYPE attribute from the LOV, and fill in the new value PP-10 for the attribute.
-
Select the Replace and With Position check boxes.
-
Click Save.
-
Click Search.
-
Click Show Result or Replace.
Screen B.20.01.29 Result Search/Replace opens.
-
Select a position and click Replace to replace the insulation type for a single position, or click Replace all to apply the change to all selected positions.
The picture below shows the result for a position.