Transfer a length to a dimension - Intergraph Smart Isometrics - Help - Hexagon PPM

Intergraph Smart Isometrics Help

Language
English
Product
Intergraph Smart Isometrics
Search by Category
Help
SmartPlant Foundation / SDx Version
10
I-Configure Version
6.0(2016)
Isogen Version
13.0(2016)
Smart Isometrics Version
2019 R1 (7.1)
Spoolgen Version
2019 R1 (9.1)
  1. Use Set Start Point and Set End Point on the Point Cloud toolbar to position measurement points over the ends of the pipe. An example is shown below.

  2. Switch to the referenced piping sketch in the Detail window, and click Dimension Pipeline Dimension Pipe on the Dimension toolbar. Alternatively, click Dimension > Dimension Pipeline.

  3. Define a start point by selecting the section of the pipe to dimension.

    You can only select discrete points on the pipeline, such as the ends of a pipe or the ends or the middle of a component. The points can span only one length of unknown pipe.

  4. Click the pipe again to define the end point.

    The software displays markers to indicate the span of the dimension, and displays an empty Dimension box.

  5. Drag Start/End Points Distance from the Point Cloud Measurements window and drop it in the Dimension box.

  6. Click File > Save to save your changes.