-
Click the Fitting list on the Place toolbar, and then select Set On Cross.
-
In the Bore Box, select the bore of the branch of the set-on cross. By default, the bore size is the same as the original pipe.
-
Click a section of pipe and route again.
The resulting sketch appears similar to the example. Notice that instead of placing a set-on cross, the software places a set-on tee. A set-on cross must connect two elements.
-
Click Fittings again to route the second element. Because the software remembers your previous selection, you do not need to expand the Fittings list and select Set On Cross again.
-
Click near the set-on tee that you placed previously.
-
Move away from the set-on tee, and then click again.
The resulting sketch resembles the example.
As indicated in the Pipeline Explorer, both components are set-on crosses (CRSO). Upon placement of the second element, the software automatically converts the set-on tee to a set-on cross.