-
In the Domain Explorer, expand the Marshaling Racks folder and right-click 101-MR-DCS-001, then on the shortcut menu, click Actions > Connection.
-
In the Connection window, from the Terminal strip list, select strip 101-MR-DCS-001, TP-1.
-
In the Cables folder of Domain Explorer, select cable C-101-MR-DCS-001 and drag it to the right side of terminal 1+v.
-
On the Cable Connection Definition dialog box, make your selections as shown.
-
Click Connect to make the connection.
The Connection window now opens where you can see the signal propagation. Use the horizontal scroll bar to see the wire, set, and cable values on the right side of the terminals:
-
In the Connection window, from the Terminal strip list, select 101-MR-DCS-001, TP-2.
-
In the Cables folder of Domain Explorer, select cable C-101-MR-DCS-002 and drag it to the right side of terminal 1+.
-
On the Cable Connection Definition dialog box, select the End 2 (MARSHALING) option button to connect the second side of the cable.
-
Click the Select all cable sets check box and select 3 in a row as the connection type for all the sets.
-
Click Connect.
The Connection window should now display the propagated tag signal as follows. Use the horizontal scroll bar to see the wire, set, and cable values on the right side of the terminals:
-
In the Connection window, click wire 101-FY-100 next to terminal 1+ and then click to open the Point-to-Point Wiring Diagram.
Note the wiring discontinuity at the marshaling rack, as the required wiring has not yet been completed
-
Print out the Point-to-Point Wiring Diagram if needed and then click to close it.
-
Click to close the Connection window.