The options on this tab allow you to determine the alignment of the title block and the relative position of the drawing area in enhanced reports that are associated with the layout.
Alignment
Displays the position of the title block origin and the edges of the drawing area on the page, when you use a symbol file (.sym) as the title block. Drag the title block icon to the required position. You can position the title block in any corner of the drawing or at the center of any of its edges. Note that the alignment does not change the orientation of the title block.
Horizontal
Select the horizontal alignment for the title block origin: left, center, or right. Note that you cannot select center for both the horizontal and vertical alignments.
Vertical
Select the vertical alignment for the title block origin: top, center, or bottom. Note that you cannot select center for both the horizontal and vertical alignments.
Drawing area relative to title block
Specifies where the drawing area should be located in relation to the title block origin. For example, if you place the title block at the bottom left corner, you can place the drawing to the right of the title block, above the title block, or above and to the right of the title block. If you place the title block at the center of any of the edges of the drawing, you can only specify one position for the drawing.
Reset
Resets the title block in its default position at the bottom left corner of the page, with the drawing area above the title block.
Size
Allows you to specify the area of the drawing sheet that the title block can occupy by setting its maximum size.
Units
Select the units to specify for the title block height or width: inches, millimeters, or twips.
Maximum size
Type a value for the maximum height or width of the title block. The dimension affected, height or width, depends on the alignment specified for the title block.
Set size
Select this check box if you want to specify a maximum size for the title block. Clear the check box to allow the title block to take up as much space as needed on the title block. It is recommended that you select this check box if the title block is very tall or very wide, to avoid overlap with other graphical elements on the drawing sheet.