This dialog enables you to use the same drawing block in different positions in different loop drawings, by defining the insertion point for individual blocks relative to the origin of the drawing (lower left corner). You can only define insertion points for block assigned to instruments using the manual block assignment method. In the Domain Explorer, these blocks are shown as .
Find
These options are not in use.
Block Default Origin
Displays the coordinates of the block origin in the currently selected loop drawing.
Tag Assignment
Displays the coordinates of the required location of the block relative to the origin of the loop drawing.
Page
Display the page number of a multi-page drawing for which the tag assignment applies. If the loop drawing is a single-page drawing, the displayed number is 1 (one).