-
Within the Citrix console, at the server location, select Start > Run.
-
On the Run dialog, in the Open box, type cmd.
-
At the command prompt, type net use.
Smart Instrumentation uses any available COM port between COM1 and COM256.
-
A summary of the mapping between local and remote ports similar to the following should appear:
If the required port, for example COM 1, does not appear in the summary, then type:
net use COM1: \\Client\COM1:.
For Windows programs to communicate with the 753 and 754 through the USB port. Download
the self-extracting installer and run it. After installed, the 753/754 will be assigned
to a Windows COM port. If necessary for the software package you are using, launch
the windows device manager and you see what COM port has been assigned. If you have
already installed DPCTrack2, then it installs this driver and it should not be necessary
to do it again. For other software that communicates with the 753/754, you will need
to install this driver. Some software will automatically find the appropriate COM
port and some will require that you manually configure it by inputting the COM port
that the 753/754 is communicating on (this is shown in the Windows Device Manager).
The Windows driver can be downloaded and installed from; Fluke 753/754 Windows Driver Download.
-
At the command prompt, type net use again and check that the required serial port is now included in the mapping.