The Draw toolbar displays by default docked to the left side of the interface. You can use the commands on this toolbar to place the basic elements of your symbol. Note that these commands are available for composite drawings only.
Select Tool
Use to select, modify, and manipulate elements.
Line
Draws one line or a series of connected lines
Tangent Arc
Draws an arc tangent or perpendicular to one or two elements.
Line/Arc Continuous
Creates lines and arcs.
Circle by Center Point
Draws a circle using a center point and radius.
Ellipse by Center Point
Draws an ellipse using the center point and two edge points.
Rectangle
Draws a rectangle using three points.
Curve
Draws a smooth, open or closed curve.
FreeSketch
Draws lines, arcs, rectangles, and circles by converting a sketch into a precision drawing.
Fillet
Draws a fillet between two elements.
Chamfer
Draws a chamfer, or bevel.
Trim
Trims open and closed elements to the closest intersection in both directions.
Extend to Next
Extends one or more open elements until they intersect with the nearest element.
Place Connector
Connects two elements together.
Revision Cloud
Places a revision cloud in the drawing.