Configure plants - Intergraph Smart 3D Web API - Update 2 - Installation & Upgrade - Hexagon

To configure plants for Smart 3D Web APIs, you use the Configuration Utility's Smart 3D Data page, plants sections.

Both APIs share the same configuration.

• If you have not yet configured the site that contains the plant you want to enable, you must do that first.

• You can also configure sites, plants, and the number of services running on a machine later using Admin API actions.

Go to the Smart 3D Data page > Plants sections

1. On any machine where the web API services are installed, open the Configuration Utility:

   Start > Intergraph Smart 3D > Web API Configuration Tool

2. On the Welcome page, select Configure Smart 3D Data.

3. Click Next until the Smart 3D Data page shows the Choose Site section at the top.

Choose Site section

• Choose the site that contains the plant.

Enable Plants section

1. To expose a plant, select it and click Enable Selected Plants .

   Once a plant is exposed, its Web API Enabled column is checked.

2. To stop exposing a plant, select it and click Disable Selected Plants .

3. To regenerate metadata for an exposed plant, select it and click Regenerate Metadata .

4. If you want to change the number of services running on this machine, click Next.