Both points cannot be placed in the same plane.
-
Meaning: When placing a volume by two points, you cannot place both points in the same plane.
-
Recovery: You must place the points in different planes when placing a volume by two points.
Boundary condition could not be created. Create an Analysis Model prior to assigning any boundary conditions.
-
Meaning: You are trying to define a boundary condition for a member without having an Analysis Model created first. Boundary conditions are assigned to an Analysis Model when they are created. Therefore, an Analysis Model must exist before you can create a boundary condition.
-
Recovery: In the Structural Analysis task, use the New Analysis Model command to create an Analysis Model. Then define your boundary conditions.
Boundary condition "XXX" may not be valid for the given geometrical conditions. Please verify.
-
Meaning: The geometry of the analytical model has changed and the existing boundary condition may not be valid.
-
Recovery: Verify that the identified boundary condition is still valid.
Branch nominal diameter is larger than header nominal diameter.
-
Meaning: While routing, you connected two runs in such a way that the branch run is larger than the header run.
-
Recovery: Modify the header or branch run size such that the branch is smaller than or equal to the NPD of the header.
Batch Update of SPRDirect fails after upgrading the Windows 10 operating system as the upgraded Windows 10 deletes the folder that was created earlier while setting up the Batch Update process.
-
Meaning: When you initially setup the Batch Update, running the ConfigureDrawingsBatch.exe under Core\Container\Bin\Assemblies\Release folder creates the folder C:\windows\syswow64\config\systemprofile\desktop. This folder is required for Batch Update process of SPRDirect. Upgrading the Windows 10 operating system deletes the newly created folder.
-
Recovery: Re run the Batch Update of SPRDirect after upgrading the Windows 10 operating system.