-
Click Select on the vertical toolbar.
-
Select the shrinkage to copy. You can select the shrinkage in the model, or from the Workspace Explorer. Set the Locate Filter to Shrinkage to make the selection easier.
-
Click Edit > Copy.
-
Click in the model to define the point from which to copy.
-
Click Edit > Paste.
-
Select the part on which to paste the shrinkage. You must select a destination that does not already have shrinkage. If the shrinkage that you copied is from a plate, you must select a plate for the destination. If the shrinkage that you copied is from a profile, you must select a profile for the destination.
-
Select the primary direction for the shrinkage.
-
Optionally, select a secondary direction for the shrinkage.
-
Click OK on the Paste dialog.