-
Click Shrinkage .
-
On the Shrinkage ribbon, select the Mode that meets your requirements.
-
Click Parts or Profiles .
-
Select the parts to which to add shrinkage.
-
You can select the parts in the model or from the Workspace Explorer.
-
Because of the different ways in which shrinkage is applied to plates and profiles, you can only select one type at a time.
-
-
Select By Vector from the Shrinkage Type list.
-
Select the selection method from the Selection Method list.
-
Depending on the selection method you chose, select the Primary and Secondary directions.
-
Type a value in the Primary Factor box.
-
Type a value in the Secondary Factor box.
If no shrinkage is needed in the secondary direction, use a Secondary Factor of 0.00.
-
Type a value in the Tertiary Factor box.
If no shrinkage is needed in the tertiary direction, then use a Tertiary Factor of 0.00.
-
Click Finish.