-
Click Shrinkage Command .
-
On the Shrinkage ribbon, select the Mode that meets your requirements.
-
Click Plates/Profiles/Assembly .
-
Select the parts to which to add shrinkage. You can select the parts in the model, or from the Workspace Explorer. However, because of the different ways in which shrinkage is applied to plates and profiles, you can only select one type at a time.
-
Click Primary Direction .
-
Select a line to indicate the primary direction for the shrinkage.
-
Click Secondary Direction .
-
Select a line to indicate the secondary direction for the shrinkage.
-
Type a value in the Primary Factor box.
-
Type a value in the Secondary Factor box. If no shrinkage is needed in the secondary direction, then use a Secondary Factor of 0.00.
-
Click Finish.