Report Parameters Dialog - Intergraph Smart 3D - Help

Intergraph Smart 3D Reports

English (United States)
Intergraph Smart 3D
Drawings and Reports
Search by Category
Smart 3D Version
11 (2016)
SmartPlant Foundation / SDx Version
7.1 (2018 R1)

Specifies parameters for a report deliverable, such as units of measure and coordinate systems.

This dialog only displays when you run a report that requires parameter input. In addition, the controls on this dialog box may vary, depending on the report definition. See Design Layout in the Reports Help.

Unit of Measure

Sets the units of measure for the report.


Specifies information about the coordinate system. See Unit of Measure Dialog Box (Label Editor) in the Common Help.

  • For some reports, several dialog boxes requiring report parameters display. The dialog boxes take the form of a wizard with Back, Next, and Finish at the bottom.

  • The query you set up for running a report can generate dialog boxes that prompt for certain report parameters. In this way, your query can customize the report creation.