Set properties for publishing documents - Intergraph Smart 3D - Help

Intergraph Smart 3D Reports

Intergraph Smart 3D
Drawings and Reports
Search by Category
Smart 3D Version
11 (2016)
  1. In the Management Console, right-click an item in the hierarchy and select the Properties Command on the shortcut menu.

  2. Go to the WBS Tab (Properties Dialog).

  3. Set the Document Type property as needed, such as Piping System Isometric or Civil Plan. This property specifies the document subtype when published.

  4. Set the Document Style property as needed, such as Iso for isometric drawing or Ortho for an orthographic drawing.

  5. Set the Discipline property. If your model has been registered using the SmartPlant Registration Wizard, this property adds the Publish command to the right-click menu for the selected document or documents. For a 3D Model Data document, the property is set to SmartPlant Review Document. For a drawing or report document, set the discipline to match the type of document.

  6. Set the Allow Publish property to Yes.

  • If you do not want an item to acquire a property from its parent, select the Override column on the Publish Dialog, then type a new value. This value propagates to other items deeper in the hierarchy.

  • The software treats blank or cleared property values as overrides.

  • Before you can publish documents, you must:

    • Install the SmartPlant Client and the SmartPlant Schema Component.

    • Register your model using the SmartPlant Registration Wizard.

    • Revise and update each document.

      Additional information about configuration is available in the Intergraph Smart 3D Installation Help.