The ModuleTypes.xls workbook contains data that applies to several of the design disciplines in the software. Module types are used in the Copy to Catalog and Paste from Catalog commands in the Common task.
Some sheets in the ModuleTypes.xls workbook, such as the Legend sheet and the Revision History sheet, are common to all the workbooks. For more information on common sheets, see Describing the Common Sheets in the Workbooks.
The sheets that are unique to ModuleTypes.xls are listed below. The delivered module types are either Equipment, Piping, or Supports types.
Equipment Module Types
-
Conveyor System
-
Heat Exchanger
-
Mixing Tank
Piping Module Types
-
Drain Arrangement
-
Pump Discharge Arrangement
-
Pump Suction Arrangement
-
Vent Arrangement
Support Types
-
Pipe Supports
-
HVAC Supports
-
Electrical Supports
-
Combined Supports
-
Designed Supports
Each of these sheets contains a class definition section and a parts definition section. The class definition is marked with the keyword Definition, and the parts definition is marked with the keywords Head/Start/End. For general information about these sections, see Part Class Sheet.
The parts definition properties as delivered on the Module Types sheets are all the same. You can type a name and description for the module type.