Specify Slope Direction Dialog - Intergraph Smart 3D - Help

Intergraph Smart 3D Piping

Language
English
Product
Intergraph Smart 3D
Subproduct
Piping
Search by Category
Help
Smart 3D Version
12.1 (2019)
SmartPlant Foundation / SDx Version
10

Defines the slope direction of a new pipe run and whether the pipe run can have multiple slope orientations (slope both up and down in the same pipe run).

High Point

Select this option to indicate that the pipe run end point that you just identified is the highest point on the pipe run.

Low Point

Select this option to indicate that the pipe run end point that you just identified is the lowest point on the pipe run.

Run contains multiple slope orientation

Indicates that the pipe run will slope both up and down. After you specify that a pipe run has multiple slope orientations, you cannot clear the selection.

You should only route pipe runs with multiple slope orientations when it is absolutely required.

See Also

Route a multi-sloped pipe run
Route a sloped pipe run