-
Click Select on the vertical toolbar.
-
Select Piping Runs in the Locate Filter.
-
Select the pipe run to move.
-
Click Move Command on the main ribbon.
-
Select a motion plane on the ribbon.
-
Select a location either on the pipe run or in the model to use as the move-from location. If you move the pipe end within ¼ inch (6.35 mm) of another pipe end, the software automatically connects the two ends. Please note that the software will lengthen or shorten the pipe length as needed to make the connection.
-
Identify the move-to point, and click on the graphic view to confirm the new location.
The software moves the pipe run to the new location.
See Appendix: Moving at Boundary Connections for information about how the software performs the move operation.