Map PDMS walls to Smart 3D walls - Intergraph Smart 3D - 2019 - Administration

Intergraph Smart 3D PDMS Design and Data Exchange

Language
English
Product
Intergraph Smart 3D
Search by Category
Administration & Configuration
Smart 3D Version
12.1 (2019)

The following steps mapping PDMS wall spec references (SPRE) and material references (MATR) to Smart 3D wall cross-sections, composition, thickness, and height as design parameters. This mapping is required prior to importing PDMS wall data into Smart 3D.

  1. Identify the PDMS wall and Smart 3D walls to map.

  2. Navigate to the [Product Folder]\3DRefData\SharedContent\Data\Translators\PDMSS3DImport folder, and open the PDMSS3DImportMapping.xls workbook.

  3. Locate the WallCrossSecCompsitionMap mapping sheet, and then map the Smart 3D wall cross-section, composition, thickness, and height values to PDMS [SPRE]-[MATR].

  4. Save the mapping file.

  5. Locate the WallCardinalPointMap mapping sheet, and then map the PDMS justification line (JUSL) to the relevant Smart 3D cardinal points.

    If a row in the sheet is highlighted yellow, then the JUSL does not have an exact match to a Smart 3D cardinal point.

  6. Save the mapping file.