Bracket Connect Points Data Tab (Bracket System Properties Dialog) - Intergraph Smart 3D - Help

Intergraph Smart 3D Molded Forms

Language
English
Product
Intergraph Smart 3D
Subproduct
Molded Forms
Search by Category
Help
Smart 3D Version
11 (2016)

Specifies the default offset values and lapped status for a bracket by supports. This tab is only visible after bracket creation when Plane by Selected Supports is selected for Select Plane.

Offset Values

Load Point

Specifies the support load point of each point used to calculate the bracket system plane. Offsets are measured from the load points. Load points are defined in the profile cross-section symbols. If one of the supports is a plate system, then the load point value is 0. See Key Points for more information.

U Offset

Specifies the offset along the local U axis of the support profile. The value is 0 if the bracket is not on the flange of a profile support.

V Offset

Specifies the offset along the local V axis of the support profile. The value is 0 if the bracket is not on the flange of a profile support.

Override

Select to specify different values for Load Point, U Offset and V Offset.

Lapped Status

Displays the status of each bracket support. Lapped is selected if the support is lapped. This value is set during bracket creation and cannot be changed here.