Name
Displays the name of the object.
Relation Type
Displays the relation that the object has to the belt:
Aligned
The object x-axis is tangent to the direction of the belt.
Angle
The object x-axis is angled based on the horizontal direction of the belt. The angle value is defined by Angle.
Arc center
The object is a pulley, or an object such as a head or tail frame that should be aligned with a pulley axis. The angle of the placed object is defined by Angle.
Relation Flags
Defines the position of the object to the belt:
Outer surface
The object is attached to the outside surface of the belt.
Z upwards
The object z-axis is upwards, preventing the object from being placed upside-down on the belt.
Offset upwards
The object offset is upwards.
Reverse direction
The object is a return idler.
Distance
Defines the distance between two reference points on the belt. Each reference point represents a pulley on the belt. A negative value represents the distance from the end reference point.
Offset
Defines the distance from the object to the belt. For the carry sections of the belt, the object is offset in an upward direction from the belt. For the return sections of the belt, the object is offset in a downward direction from the belt.
Angle
Defines the angle of rotation of the object to the belt. This angle is counter-clockwise.
Apply
Applies the values to the object.
OK
Applies the values to the object and closes the dialog.
Reset
Discards any changes that have not yet been finalized by clicking OK.
Close
Closes the dialog.