Specifies a plotted leg length for elbows, tees, and crosses. Leg Length does not apply to fabricated (pulled) bends or set-on (stub-in) type tees or crosses.
Specify the required leg length in whole millimeters. For example, for a 12mm leg length, type 12.
-
The maximum suggested value is 18 (18mm), and the minimum suggested value is 6 (6mm).
-
If you set the Leg Length to 0, the software uses a default value of 9mm.
Defines:
Option Switch - 95
I-Configure - Drawing.Format.ComponentLegLength