Use the command below in Smart 3D Project Management to define your required Integration Service options.
You must have administrator permissions for the model you are configuring.
-
Select the model for which you want to configure the settings from the Project Management tree. The model must be registered with a valid HxGN SDx2 server. See the Register with SDx Command.
The software does not currently support configuring Integration Service settings for a Change Management model.
-
Select Integration > Configure SDx Integration Settings Command to open the SDx Integration Settings Dialog.
-
Specify the options to configure the settings as needed.
-
Select Save to save your settings in the database.
-
Select OK to close the confirmation message.
If the Integration Service is running at the time you configure your settings, the software begins sending the corresponding model database to HxGN SDx2. Service-wide log files are written to the temp folder during startup of the synchronization. After the synchronization starts successfully, the model-specific log files are written to either Application Insights (if enabled) or the defined Log File Location (if enabled) as defined in the Integration Service settings.
Optionally, you can use a command-line executable to configure some of the service
settings. See Command-line option to configure HxGN SDx2 integration settings.