Recover data from SDx - Intergraph Smart 3D - Administration & Configuration - Hexagon PPM

Intergraph Smart 3D Integration - Project As-Built with HxGN SDx

PPMProduct
Intergraph Smart 3D
PPMCategory_custom
Administration & Configuration
Version_SThreeD_Custom
13
SPFVersion_custom
10

After you restore a Change Management model to a previous state from backup, you can use the Data Recovery from SDx Command to recover lost data and re-sync the model with SDx.

Before using the Data Recovery from SDx Command make sure that you re-register the restored model to the same SDx plant as was used for the previous SDx registration. After you re-register the restored Change Management model, you must define SDx subscription settings. Otherwise, the software displays an error message.

  1. Select the restored Change Management model in the Project Management tree.

  2. Click Integration > Data Recovery from SDx Command to open the Data Recovery from SDx Dialog.

  3. Wait while the software runs the processes displayed on the Project Details tab.

  4. After all processes are complete, use the Details panel to review the synchronization status for a project category.

  5. Click the Recovery tab, and then click Recover to recover the data from SDx and synchronize the Smart 3D model to SDx.

  6. When the data recovery processes are complete, click Close.

  • If any process fails during data recovery, the software displays a message.

  • The software records the results of all the processes in a log file. Click View Log to open the log file in your default text editor.