You must select Show Dimension for the key point to show on the fabrication drawing. A dimension must have at least two key points with Show Dimension selected.
-
In the Workspace Explorer or a graphic view, select a support to which you want to add a dimension.
-
Click Properties to display the Support Properties Dialog.
-
On the Notes Tab, select a Key Point for the start of the dimension.
-
Click New Note.
-
In the Notes at this location, listed by name box, type a name for the note.
-
In the Purpose of Note box, select Fabrication.
-
Click OK.
-
Repeat steps 3 to 7 to add a key point at the end of the dimension.