Offset Properties - Intergraph Smart 3D - Reference Data - Hexagon PPM

IJUAhsSBTopOffsetDef::TopOffsetDef

Specifies the offset for the top attachment. The default codelist value is set to 1. This property uses the following hsSBeamOffsetDefinition codelist values:

1 = From Center
2 = From Edge

IJUAhsSBeamTopOff1::TopOff1

Specifies the distance from the center or edge of the beam to the center of the top1 attachment. The codelist value cannot be negative.

IJUAhsSBeamTopOff2::TopOff2

Specifies the distance from the center or edge of the beam to the center of the top2 attachment. The codelist value cannot be negative.

IJUAhsSBBotOffsetDef::BotOffsetDef

Specifies the offset for the bottom attachment. The default codelist value is set to 1. This property uses the following hsSBeamOffsetDefinition codelist values:

1 = From Center
2 = From Edge

IJUAhsSBeamBottomOff1::BottomOff1

Specifies the distance from the center or the edge of the beam to the center of the bottom1 attachment. The default value for BotOffsetDef is 1.

IJUAhsSBeamBottomOff2::BottomOff2

Specifies the distance from the center or the edge of the beam to the center of the bottom2 attachment. The default value for BotOffsetDef is 1.

IJUAhsSBMiddleOffsetDef::MiddleOffsetDef

Specifies the offset for the middle attachment. The default codelist value is set to 1. This property uses the following hsSBeamOffsetDefinition codelist values:

1 = From Center
2 = From Edge

IJUAhsSBeamMiddleOff::MiddleOff

Specifies the distance from the top middle attachment to the center or edge of the beam.