IJUAhsSmartShapeType::SmartShapeType
Specifies the classification of the shape. This property uses the codelist number defined in the hsSmartShapeType sheet in the HS_S3DParts_Codelist.xls workbook.
IJUAhsOpening1::Opening1
Specifies the distance from the pin centerline to the inside face of the end nut.
IJUAhsShape1::Shape1Type
Specifies the codelist number of the shape type as defined in the hsShapeType sheet in the HS_S3DParts_Codelist.xls workbook.
1 - Round
2 - Square
3 - Hex
IJUAhsShape1::Shape1Width1
Specifies the outside dimension of the end nuts. If this value is zero, the end nut shapes are not displayed.
1 - Round
2 - Square
3 - Hex
IJUAhsShape1::Shape1Width2
Specifies the value only for NutShape2 (square). This value is used to create a rectangular nut instead of a square nut. If the value is zero, or is not specified, NutShape2 is drawn as a square.
IJUAhsShape1::Shape1Length
Specifies the thickness of the end nut shape. Only positive values are acceptable. If this value is zero or negative, the end nut shape is displayed.
IJUAhsDiameter2::Diameter2
Specifies the outside diameter of the round ends of the clevis. If this value is negative or zero, the round ends are not drawn.
IJUAhsThickness2::Thickness2
Specifies the thickness of the round ends of the clevis. If this value is negative, then zero is used.
IJUAhsGap2::Gap2
Specifies the gap between the round ends of the clevis. If this value is negative, then zero is used.
IJUAhsWidth3::Width3
Specifies the width of the side blocks. If this value is negative or zero, the side blocks are not drawn.
IJUAhsThickness3::Thickness3
Specifies the thickness of the side blocks. If this value is zero, the software uses the value defined for Thickness2. If this value is negative, the side blocks are not drawn. If both Thickness2 and Thickness3 values are 0, the side blocks are not drawn and a warning is displayed.
IJUAhsOverLength1::OverLength1
Specifies the amount by which the side blocks are to extend beyond the inside face of the end nut shape.
IJUAhsOverLength2::OverLength2
Specifies the amount by which the side blocks are to extend beyond the bolt or pin centerline. OverLength values are used when there is no need for a round end shape, resulting in the rectangular side blocks being extended to hold the bolt or pin. This value can be positive or negative. If a positive value is used, no round ends are shown.
IJUAhsPin1::Pin1Diameter
Specifies the diameter of the bolt or pin. Use this property as a connection diameter from the assembly information rule when joining between the clevis and eye nut. If this value is zero, the pin is not drawn.
An assembly information rule that joins a clevis to an eye nut reads Pin1Diameter from the clevis and passes it to the PinDiameter prompt of the eye nut.
IJUAhsPin1::Pin1Length
Specifies the length of the bolt or pin. If this value is zero, the pin is not drawn.