The following properties are outputs and should be left as blank on the part XLS sheet. These properties are calculated and set by the SmartPart symbol code.
IJUAhsRodTakeOut::RodTakeOut
Specifies rod take out at the installed position.
IJUAhsTotalTravel::TotalTravel
Specifies the required total travel for the given movement.
This is calculated by taking the maximum of the following two values:
Movement + OverTravelMin
OR
Movement(1 + OverTravelPercent)
IJUAhsRodDiameter::RodDiameter
Specifies the diameter of the rod. RodDiameter value is determined based on size, total travel, or load from the Dimension Reference tables.
IJUAhsHoleDiameter::HoleDiameter
Specifies the diameter of the hole. HoleDiameter value is determined based on size, total travel, or load from the Dimension Reference tables.