Swivel Ring Properties - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13

IJUAhsRodDiameter::RodDiameter

Specifies the outside diameter of the rod that attaches to the swivel ring. The rod does not display as part of the swivel ring and does not affect the graphics. The rod diameter value is mandatory. If the value is set to zero, a warning displays.

IJUAhsRodTakeOut::RodTakeOut

Specifies the distance from the pipe centerline to the bottom of the rod. This value specifies the location of the rod end port. This value must be greater than Height1 + (2 X Thickness1).

IJOAhsPipeOD::PipeOD

Specifies the outside diameter of the pipe. This value must be greater than zero. It determines the inside diameter of the clamp unless Diameter1 greater than PipeOD.

The band curve does not necessarily stop at the pipe centerline. This curve wraps around the pipe until a tangent line can be drawn from the edge of the pipe to the lower face of the top on that side.