Block Properties - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13

The block properties are optional and can be used to specify two stacked rectangular blocks that are used to represent slide plates, shims, insulation pads, cradles, and so forth. Enter the values for these properties only when Block geometry is required.

The position of Block 1 is exactly Gap1 below the bottom of the strap. The position of Block 2 is on top of Block 1. Both blocks have similar input properties: height, width and length. The blocks are not included if any of these values are set to zero.

IJUAhsGap1::Gap1 (Optional)

Specifies the distance between the bottom of the strap and the top of Block 1. This distance value can be a negative, zero, or a positive value.

IJUAhsHeight1::Height1 (Optional)

Specifies the height of Block 1.

IJUAhsWidth1::Width1 (Optional)

Specifies the width of Block 1.

IJUAhsLength1::Length1 (Optional)

Specifies the length of Block 1 in the direction of the pipe.

IJUAhsHeight2::Height2 (Optional)

Specifies the height of Block 2.

A

IJUAhsWidth2::Width2 (Optional)

Specifies the width of Block 2.

IJUAhsLength2::Length2 (Optional)

Specifies the length of Block 2.