IJUAhsStrutRiserAngle::RiserClampAngle
Specifies the orientation of the entire riser about the pipe. The default value for RiserClampAngle is 0 Deg.
IJUAhsStrutRiserAngle::Strut1Angle
Specifies the angle that rotates strut A, along the structure, about the connection to the pipe clamp. You can type the angle you require for strut A. The default value for Strut1Angle is 0 Deg.
The pipe attachment remains attached to the pipe and the structure attachment is
moved along the structure to put the strut A at the specified angle.
IJUAhsStrutRiserAngle::Strut2Angle
Specifies the angle that rotates strut B, along the structure, about the connection to the pipe clamp. You can type the angle you require on strut B. The default value for Strut2Angle is 0 Deg.
The pipe attachment remains attached to the pipe and the structure attachment is
moved along the structure to put the strut B at the specified angle.
IJUAhsStrutOffsets::Offset1
Specifies the offset from the center of the riser clamp to one end of the riser clamp. The default value for Offset1 is -1. If you type a negative value for Offset1, graphics are not affected.
IJUAhsStrutOffsets::Offset2
Specifies the offset from the center of the riser clamp to the other end of the riser clamp.The default value for Offset2 is -1. If you type a negative value for Offset2, graphics are not affected.