Route selection commands on the shortcut menu allow you to select a section of a route network to modify. These commands simplify the selection of a specific section of a network. For example, if you want to modify a leg along with its supports, select the leg using On Same Leg, and add the hangers supporting the leg using the Get Connected Supports Command.
The route selection commands do not support combined features that belong to different tasks. For example, you cannot combine Piping and HVAC features, or Electrical and HVAC features.
Depending on the active Locate Filter, different route selection commands are available.
Locate Filter |
Available Commands |
All |
Get Duct Runs (only in Workspace Explorer) |
Duct Features |
Get Features |
Duct Parts |
|
Duct Runs |