Route a new duct from a nozzle or end - Intergraph Smart 3D - Help - Hexagon

Intergraph Smart 3D HVAC

Language
English
Product
Intergraph Smart 3D
Subproduct
HVAC
Search by Category
Help
Smart 3D Version
13.1
  1. Click Route Duct Command on the vertical toolbar.

  2. Select an existing nozzle or component end from which to begin routing the duct run. When you select a nozzle or component end, the software sets the cross section of the duct to match the cross section and orientation of the nozzle or component.

  3. If you start routing from a nozzle, then the General Tab (New Duct Run Dialog) displays. If necessary, change the settings for the new duct segment on the ribbon.

  4. Place the end point for the duct run.