Get Features - Intergraph Smart 3D - Help

Intergraph Smart 3D Electrical

Language
English
Product
Intergraph Smart 3D
Subproduct
Electrical
Search by Category
Help
Smart 3D Version
12.1 (2019)

If you have the Locate Filter set to Cable Tray Parts or Conduit Parts, then Get Features selects the parent feature of the selected part or parts.

If you have the Locate Filter set to Conduit Runs, Enclosed Runs, or Enclosing Runs, then Get Features selects all the features in the selected run.

If you have the Locate Filter set to Cableway/Conduit Path Features, Cableway Features, Conduit Features, or Enclosing Features, then Get Features contains a group of commands that allow you to select part of a targeted route network. The Get Features commands apply to features that are in the select set and are defined in the workspace. You can select one or more features on the network.You can also use a combination of the following commands to extend the targeted network as necessary.

On Same Run

Selects all features that belong to the same run even if the run is discontinued.

On Same Leg

Selects all features that belong to the same leg. The software also includes the along-leg feature if the selected leg is a branch.

A leg is a group of route features routed in the same direction.

On All Connected Branches

Selects all features associated with the connected branches. Select an along-leg feature that has a branch connected to it. Right-click the along-leg feature, and then select On All Connected Branches. The software selects the associated features connected to the branch run until it branches into a header run, or until a free end is traversed.

For Connected Fittings

Adds the immediate connected fittings to the selection. You must select a branch component.

SHARED Tip You can select a leg using On Same Leg, and then use For Connected Fittings to add all the adjacent branch fittings on that leg to the selection.