Insert a single cable tray split - Intergraph Smart 3D - Help

Intergraph Smart 3D Electrical

Language
English
Product
Intergraph Smart 3D
Subproduct
Electrical
Search by Category
Help
Smart 3D Version
12 (2018)
  1. Click Insert Split .

  2. Click a cable tray straight feature.

    SHARED Tip If the length of the selected cable tray straight feature is less than the last-used section length, then the software sets the section length to half of the straight feature length.

    Insert a single cable tray split STEP SELECT TRAY

  3. In the Split Mode box, select Single-Split.

  4. To fine-tune the location of the split, click Position , and slide the split along the feature.

    Insert a single cable tray split STEP POSITION

  5. Click when it is at the location you want.

    SHARED Tip Instead of using Position, you can adjust the section length, gap, and reference position boxes on the ribbon to adjust the location of the split.

  6. Click Finish.

    Insert a single cable tray split STEP FINISH