Route multiple, parallel cableways - Intergraph Smart 3D - Help

Intergraph Smart 3D Electrical

Language
English
Product
Intergraph Smart 3D
Subproduct
Electrical
Search by Category
Help
Smart 3D Version
11 (2016)
SmartPlant Foundation / SDx Version
10

You can route multiple, parallel cableway or cable tray runs in either Along Depth (stacked) or Along Width (side-by-side) mode.

To route multiple, parallel cableway runs, use Route Cableway and set options as needed on the Multi-Route Tab (New Cableway Dialog). The software creates a master run and several slave runs. When you route the master run, the slave runs follow along. You can specify the number of slave runs above and below or to the left and right of the master run.

After the cableways are routed in the model, they are individual cableway runs without relationships to each other. For example, you can change a property on the master run and it does not affect any of the slave runs.

The Multi-Route tab is not available when a Duct Bank specification has been selected on the General tab.

What do you want to do?