Conduit Filter - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Electrical Reference Data

Language
English (United States)
Product
Intergraph Smart 3D
Subproduct
Electrical
Search by Category
Reference Data
Smart 3D Version
13

The Conduit Filter node (the sheet in the Conduit.xls workbook) defines the data required to select the conduit commodity when routing.

Bend Radius

Allows you to assign the turn radius to use while routing. The throat radius can determine the proper cables to use within the conduit. The software considers rules for the default throat radius for routing.

Bend Radius Multiplier

Specifies a factor used in determining the absolute bend radius value, which is the product of the nominal diameter times the bend radius multiplier.

Comments

Type an optional brief description of the conduit commodity.

Commodity Option

Type an option code. Valid entries are listed in the AllCodeLists.xls workbook on the Commodity Option sheet in the Codelist Number column. The option code gives the software a way of recognizing the default component when more than one component will work.

Contractor Commodity Code

Enter the contractor commodity code, which is the commodity code that is used during the design phase.

First Size From

Defines the lower bound of the largest nominal diameter for which this conduit commodity applies within the conduit materials class.

First Size To

Defines the upper bound of the largest nominal diameters for which this conduit commodity applies within the conduit materials class.

First Size Units

Specifies the units for the First Size From and First Size To columns. For example, you could enter in for inches or mm for millimeters.

Short Code

Type a short code for this row. A short code is used as a grouping or designation for each component so you can select the component. The software uses the short code to automatically insert components. An example for conduit is Conduit Bend. To create new short codes, go to the Tools Menu > Options Command in the Catalog task, and then select the Short Codes Tab (Options Dialog). Scroll to the bottom of the list and type a new short code in the blank line. Click Apply.

Second Size From

Defines the lower bound of the next largest nominal diameter for which this conduit commodity applies within the conduit materials class.

Second Size To

Defines the upper bound of the next largest nominal diameters for which this conduit commodity applies within the conduit materials class.

Second Size Units

Specifies the units for the Second Size From and Second Size To columns. For example, you could enter in for inches or mm for millimeters.

Selection Basis

Defines values that indicate if the conduit is available for the designer to select manually or only for selection as a result of a rule. Valid entries are listed in the AllCodeLists.xls workbook on the Conduit Selection Basis sheet in the Codelist Number column.

Spec Name

Specify the conduit specification (materials class) for which the conduit commodity is intended. You must define the conduit specification in the Conduit Specifications node (on the ConduitSpec sheet) before you can use it.

See Also

Define Conduit Filters