Generates dimension points for certain types of openings. The placement of points on the opening depends on the type of opening that you are dimensioning. Alternately, the points are placed at range vertex points.
You can generate dimension points for the following types of openings.
-
Rectangle. The software generates points at each corner of the opening. The angles of the rectangle must be 90 degrees.
1 - Dimension points |
-
Circle. The software generates a point in the center of the opening.
The software does not support dimensioning ellipses.
1 - Circular opening |
-
Square and rounded corners. The software generates points at the expected intersection of the lines. The arc angle must be 90 degrees.
1 - Dimension points |
-
Slot. The software generates points at the ends of each arc. The arc angle must be 180 degrees.
1 - Dimension points |
Usage in Dimension and Label Template XML
<pointGeneratorSettings>
<pgModule>DrawingPGOpeningObjects</pgModule>
</pointGeneratorSettings>
Customization
None